Pfaff Extra Heavy Duty 60

[coboring]

I'm looking for the type and model number for the lightbulb. Any help for fixing the lowering bar/ mechanism would be most appreciated!

[Constabulary]

You need bulbs with B15D sockets. At least the Pfaff I know used them. There are also LED bulbs with this socket.

[Constabulary]

BTW - the OEM Pfaff bulb is 62mm long and has a 22mm diameter just to give you an idea. Smaller bulbs may fit as well but I have installed a LED bulbs in my Pfaff 368 and it has a small diameter (16.5mm dia. and 56mm long) and it was a little bit fiddly to install them (grab, push & twist) because of the smaller diameter but it worked.

The OEM bulbs on my side of the pond usually were 12V but they come in 220/230V and 110V as well so depends on what your voltage is.

Edited April 6, 2024 by Constabulary

[Constabulary]

Regarding needle bar - I guess its the same as on my 368 so pull off the top lid, loosen the screw of the face plate (comes form the top side) and bring the needle in bar in the lower position and then you can see the needle bar clamping screw.