cowboycolonel Report post Posted September 4, 2016 I'd like to find someone who could put me on the trail of an arch punch that could be used to make cutouts for rigging rings. 2 3/4 inch would be perfect, but with the taper on the inside. Or maybe someone has a better idea? Quote Share this post Link to post Share on other sites
JLSleather Report post Posted September 4, 2016 Any of the die makers listed around here should be able to make that for you easily. Some of them listed below in alphabetical order ... Economy Die Makers (ON Canada) http://www.economydiemakers.com/ Global Die (Auburn, ME) http://globaldie.com/ Intl Die (Clarkesville, GA) http://intdieco.com/ National Steel Rule Die (Vandalia, OH) http://www.nationalsteelruledie.com/ Progressive Service Die Co (No Carolina) http://psdcdies.com/index.html Texas Custom Dies (Mansfield, TX) http://www.usacuttingdie.com/ Should be able to get this "flat" - for use in a clicker press - or with a handle for mallet use. Quote Share this post Link to post Share on other sites
cowboycolonel Report post Posted September 6, 2016 Thanks JL. I had a local guy make one for me, but he botched the job so badly that all I ended up with was a bad paperweight. Quote Share this post Link to post Share on other sites
