45K Oscillating shaft bent

[studioBT]

Update... So I'm happy to say that I was able to fit a replacement shaft sourced from @Uwe without too many issues (although taper pins are always fun). After half an hour re-timing everything I'm happy to say my 45K is now sewing beautifully again. They really are tanks, here you can see nice even stitches through 3/8" (approx 9mm) of dense veg tan - no worries.

Thanks to all for the advice/help sourcing parts.

On another note hook to needle timing is no worries but timing the feed and jump foot lift was basically trial and error - Does anyone know of any literature (a service manual perhaps) that documents this?

[Chayse]

Awesome news and am glad it is back in service! One has to wonder where @Uwe keeps all of these spare parts!!

[ddiuni]

On 2017. 7. 11. at 오전 12시 50분, Yetibelle said:

나는 그것들 중 몇 개를 가지고 있지 않습니다. 오늘 밤 집에 갈 때 부품 번호를 확인하겠습니다. 

 

Do you have a 45k56 feed, presser foot and throat plate?