fancy boot plate

[Studio-N]

here's a little fancy boot embossing plate I finished up today on the HAAS cut in aluminum. broke my 1/16" ball nose bit on this one. I'm going to have to start buying those things by the box load. I seem to get only 2 projects out of one. cheers!

[Sanch]

That is fancy!! What are the dimensions?

[Studio-N]

thank you. it is basically 2.7 x 2.25

[Sanch]

13 hours ago, Studio-N said:

thank you. it is basically 2.7 x 2.25

What is the smallest Maker's Mark you have done in Delrin

[Studio-N]

10 hours ago, Sanch said:

What is the smallest Maker's Mark you have done in Delrin

3/4" and only with a solid border. the limitation is the size of the letters. anything below 6 points will fail. at 3/4" it is visible but not ideal.

[Sanch]

8 hours ago, Studio-N said:

3/4" and only with a solid border. the limitation is the size of the letters. anything below 6 points will fail. at 3/4" it is visible but not ideal.

Hmm. Still have an idea for my makers mark 2.0 and @ 3/4" that would be ideal size I may be in touch soon to bounce ideas your way and get a quote if possible.