Members Tazz63 Posted November 26, 2017 Author Members Report Posted November 26, 2017 does anyone know if I can use the Juki DNU 1541 engineer's manual to adjust the feed dogs on this machine. I've been looking for a Juki DNU-241HS repair or service manual without any luck, I know trying to find the Chandler manual is impossible. I've even looked for the Nakajima 280l manual and nothing. Quote
Members Tazz63 Posted November 26, 2017 Author Members Report Posted November 26, 2017 Sure, please post it if you can Quote
Members Tazz63 Posted March 9, 2018 Author Members Report Posted March 9, 2018 (edited) Well after a long winter and some parts from Gregg I finally got this machine running. The rocker shaft that moves the needle bar back and forth in unison with the feed dogs was broken. Got some new parts, brought that shaft to my local welder and is all good now. Geeze, I had this whole machine taken apart, at least I know it inside and out now. Here it is, these are just some scraps that I stithed, ddon't forget that I've really never sewn before either. The red suede is 4 layers thick, about a 1/2 inch thick. Edited March 9, 2018 by Tazz63 Quote
Uwe Posted March 9, 2018 Report Posted March 9, 2018 Nice looking stitches! You did a great job bringing this machine back from the semi-dead. And you're now well equipped skill-wise to keep it running for decades. Quote Uwe (pronounced "OOH-vuh" ) Links: Videos
Members Tazz63 Posted March 9, 2018 Author Members Report Posted March 9, 2018 1 minute ago, Uwe said: Nice looking stitches! You did a great job bringing this machine back from the semi-dead. And you're now well equipped skill-wise to keep it running for decades. Thanks to some of your videos also...... Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.