halters Raised Nose Piece, Halter Making

[Silverd]

Hi

I found nothing out of the ordinary during my delve into the Claes  head.  And it sews perfectly as long as the material is sufficiently thick so the presser foot can reach.  

My theory at this point is that the cylinder arm is been bent down.  Have you seen this before?  Can you possibly measure the distance between the needle plate and bottom of head on your machine for me?

 

Silverd

 

 

Edited December 5, 2018 by Silverd

[Silverd]

Hi Constabulary,

When I had the head taken apart I measured the needle diameter bar at wear area and non wear area.  The difference is about 0.003" -0.004".  I think replacement is warranted.  The presser foot cam also shows sign of wear which probably contributes to the reduced max stitch length possible on my machine.

I can buy these parts from Landis int. In Canada, but was wondering if you have access to them?  Also, you included a repair manual that looked very useful.  Is that for sale by chance, or would you consider selling a photo copy version?

Thanks!

Silverd