What size English point do I need for a 1" or 25 mm end opening

[DONAG]

Years ago I bought a 1" Tandy punch.  Turns out it was 1 3/16ths" wide at the opening.  Thought someone made an error and ordered another which was the same size.

Seems it's measured from the tip to the back edge which seems kind of stupid

Been using it for 26, 24 and 22 mm, but angle gets worse by the time I use for 24 and 22 mm

I figure an opening of 25 mm or 1" should be OK for the 2 smaller widths

If anyone can measure one of theirs.  I'd appreciate it.

Thanks

DON

[SaddleBags]

Osborne 151 punch is right on 1". 

[DONAG]

I just checked and the 151 is an elongated hole punch

I'm looking for an English Point tip punch listed as 150 on a site

Thanks

DON

[SaddleBags]

you are right, however, my English point tip punch is stamped with "151" as are all of my bag punches.  in any case, it's made by Osborne, no matter how it's marked, and the dimensions are true. 

Edited November 30, 2018 by SaddleBags