DONAG Report post Posted November 29, 2018 Years ago I bought a 1" Tandy punch. Turns out it was 1 3/16ths" wide at the opening. Thought someone made an error and ordered another which was the same size. Seems it's measured from the tip to the back edge which seems kind of stupid Been using it for 26, 24 and 22 mm, but angle gets worse by the time I use for 24 and 22 mm I figure an opening of 25 mm or 1" should be OK for the 2 smaller widths If anyone can measure one of theirs. I'd appreciate it. Thanks DON Quote Share this post Link to post Share on other sites
SaddleBags Report post Posted November 30, 2018 Osborne 151 punch is right on 1". Quote Share this post Link to post Share on other sites
DONAG Report post Posted November 30, 2018 I just checked and the 151 is an elongated hole punch I'm looking for an English Point tip punch listed as 150 on a site Thanks DON Quote Share this post Link to post Share on other sites
SaddleBags Report post Posted November 30, 2018 (edited) you are right, however, my English point tip punch is stamped with "151" as are all of my bag punches. in any case, it's made by Osborne, no matter how it's marked, and the dimensions are true. Edited November 30, 2018 by SaddleBags Quote Share this post Link to post Share on other sites
