Members RQR Posted February 15, 2021 Members Report Posted February 15, 2021 Hello all, long time lurker, first time poster. What a great forum! I have a durkopp 212 needle feed which has play in the needle bar. I've searched long and hard for an eccentric screw etc. to no avail. Would a good first step be to change the needle bar? Or could the problem stem from a worn bearing? The stitch quality is still very good but I'd like this machine to be back on top form again! Thanks Quote
Members CarlosD Posted October 14, 2024 Members Report Posted October 14, 2024 On 2/15/2021 at 9:46 AM, RQR said: Hello all, long time lurker, first time poster. What a great forum! I have a durkopp 212 needle feed which has play in the needle bar. I've searched long and hard for an eccentric screw etc. to no avail. Would a good first step be to change the needle bar? Or could the problem stem from a worn bearing? The stitch quality is still very good but I'd like this machine to be back on top form again! Thanks Hi, what type of needles do you use? I am looking for the specific needles for the same machine Quote
Members CarlosD Posted October 14, 2024 Members Report Posted October 14, 2024 Hi, what specific needle reference do you use on this machine? SY 1968? Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.