Members Pianoguy Posted March 14, 2021 Members Report Posted March 14, 2021 I have a consew 118 and I am having trouble with getting it to sew. When I got it the needle bar was striking the foot so I did a rough adjustment. When I first tried to sew it worked for about six inches then it started to jam. I bought a servo motor for it to make it run more manageable. Before I install it I have been trying to readjust the needle bar height and cycle it by hand. I can't seem to get it to sew again. There doesn't appear to be any way to adjust the hook timing so I'm not sure what to do. Quote
Members Constabulary Posted March 15, 2021 Members Report Posted March 15, 2021 (edited) Needle hook timing should be the same as for the Singer 16 Class machines cause it has a CB hook and is using sys. 16 needles as well. Try this: Edited March 15, 2021 by Constabulary Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.