flyingpumpkin

I have a reliable barracuda 200zw (similar to a sailrite 200zw) It has a flat asymmetric pin connector for a classic foot pedal/ac power connection to the external machine-mounted motor. I am designing my own replacement speed controller and want to use the existing connector. I know I can buy a wired pedal and cut it but for ease of experimentation I was hoping to connect wires to a banana style or pin jack. To plug into the existing motor Lowe without cutting wires. I don’t know the size of the pins/sockeys. AI says try 2.8mm and then 1.5mm but I’m not convinced it’s right about anything. Im not near the machine. photo of the typical connector foot controller (female connector) https://a.co/d/fpXFvPf machine side connection:Socket connection (male pin) https://a.aliexpress.com/_mtRUCn9

I’d really love to start a portable clone hot-rodding blog. I put a bobbin tensioner on the top side for winding while I sew. It’s based on a barracuda concept machine they never sold ****Did you make progress on a suspended edge guide? I’d like to know which one to buy. I will drill holes , or 3M tape to start or weld nuts before I make it permanent but I don’t want to buy the wrong model. They are adjustable but not infinitely so there are nice ones where you can swap the roller guide out with a flat edge guide. I want to get rid of my magnets and swing away attachments