Craftt

the handle on the cobra 4 bell skiver will not go back up after sharpening. thanks for any help

Thanks but I hope I never have to make another one

Finished the sheath with a wedge made from layers of leather.

Can’t change knife doesn’t belong to me.

Need help with knife sheath that has .5” between blade and guard? Do I just build up the outside edges tapering down to the point?

Need to know what to do when there is a .5” difference between blade and Guard

Great thanks to both. I did watch a lot of videos last night and I got the idea it was best to put a curve in it.thanks again and God Bless right back

i am looking for help with using the edge beveler on inside corners such as on a knife sheath that is folded over with the belt above the sheath. Places where there is a 90* degree inside corner where the beveler does not go all the way into the corner. thanks craftt

That did it thaks

Thank you I'll try tomorrow

Hi all I just purchased a cobra 26 and probably caused the problem myself but don't know what I did so I don't know how to fix it. I am getting loops on the bottom side of leather when I use reverse. Any help will be appreciated. Also is there a (factory set) on tension to begin with (like tighten all the way and back off one or two times) for both the primary and the bobbin?

Welcome being a sw mo person also. Sunrise beach. Try Springfield leather for some of your stuff and ask about the wholesale membership. I really enjoy the store.

Patty i checked out your facepage and you are doing a very good job. Looks like you have the colors down ok. cindy

who of us have ever transposed letters in a name to ruin a project? I did recently but this was my solution for salvaging the project. the name Leah was to be under the bible, but i started it looking at the letters three times and still put the a before the e. there goes it!!!!!!

thanks for all the respones. i just did a guitar strap and did put it where the adjustment strap covered it. i do like the way it was incorporated into the pattern on the back. thanks all