Search the Community

Help!! The presser foot lifter on my skiver will not stay down. It feels like the spring is shooting it back up whenever I try to skive. I have taken apart my consew dcs-s4 skiver 3 times to try to figure this out but cannot. The instruction manual is really only a parts catalog and doesn’t offer help. The spring inside looks fine. The rare occasion I get the handle to stay in the down position, it will skive for a moment the the handle shoots up and releases the presser foot so it doesn’t skive anything off. I bought it from a sewing shop that recently started carrying skivers for the pandemic demands so they aren’t very familiar with skivers and cannot offer much help. 66285906847__CB624500-FA42-4BA4-A712-97BE830DE189.MOV

Good afternoon, Brand new to me Singer 211G165 I've acquired as a very dirty barn find. This is my second machine, but first industrial. I previously refurbed an old Singer 403A and it is performing flawlessly. I'm a newbie overall - worked on a few creations on the 403A - and I'm interested to begin crafting heavier items including canvas, leather, and vinyl. This forum has been invaluable already and a prime source for great info on these older industrial machines. I already have several manuals and the parts list downloaded and have begun study. My first step is some heavy cleaning which is in process, followed by a thorough lube and setup audit. I've yet to try to sew. Any input on best steps forward is welcome! I have a few questions already that could help me quickly finding parts and information: 1) the 111W155 seems to be the grandfather of many of these machines and I see references to cloned models by other makers. Are there any direct clone brothers to my own Singer 211G165 from Juki, Brother, TecSew or others that I can freely interchange parts from? Which of their models? I do see there are G, U, and A versions of my 211 and I have their materials. 2) I've already noticed that the presser lever in the rear is gone. It has a pedal lift but I would really like to reset it to stock and have something that can lock it in the raised position (the pedal doesn't lock when raised). I've done a ton of online parts searching for presser lift lever part #508309. I can't find it anywhere. Can anyone help with best sites or where to try to find one? If not could the sister machine's levers work on mine? 3) I have a lot of screws that are chewed up and a couple are missing (e.x faceplate only has 1 screw intact). Are these pretty generic or do you need to find every nut, screw, and set screw by their specific location and part #? Again I'm worried about sourcing these. 4) Adjusting the stitch length per the manual works OK but doesn't appear to be changing the motion range of the feed dogs or needle.... will need to look at this one for sure. Something locked up maybe? Thanks for sharing your experience as I get underway! Bruce