3 in 1 arbor press

[Frodo]

modified my arbor press

removed the geared press arm

using a 1/4  rod coupling

forcefully with great care, drive the coupling into the tool recover hole in the. The presser arm

 

 
 

grind the rod coupling  so it fits OnTo the aluminum stamp

using a drill bit, remove the threads inside the rod kkcoupling. 

Cut a 1/4” rod 1.5” long  , grind one end to a dull point

nowlets use the machine

1)…. Flip/invert the anvil that comes with the press. Use this tool to press large acrylic stamps,  I have pressed stamps up to 6” diamieter 

2).   Press for stamps

3)..   remove the selector wheel from a broken hand punch, remove one of its cutter dyes

Ram will press down on the cutter dye to punch holes

[AlZilla]

1 hour ago, Frodo said:

forcefully with great care

My favorite method for many things ...

[Frodo]

11 hours ago, AlZilla said:

My favorite method for many things ...

I stole that line fro an engineer in Texas

the plan called for a floor sink to be installed at a location that had a 4’x2’section of duct work in the way

I issued an RFI. And waited for an answer engineers answer was to forcefully with great care manipulate the top of the duct work to accommodate the p-trap (IE. Beat it)  

This work was taking place in a university kitchen that was in operation.  I came down my ladder stole a stainless steel mixing bowl  cut round hole in the duck and set the bowl in it with the p-trap nestled in the bowl like a baby bird

The salad chef looked for his mixing bowl for an hour before  he gave up  

side note,  shout out to a plasma cutter called Drag-un awesome awesome tool