rktaylor Report post Posted January 20 Does anyone have instructions for sharpening rosette cutters? I have two punches from Weaver that are woefully dull. Thanks, Randy Quote Share this post Link to post Share on other sites
DieselTech Report post Posted January 20 Just now, rktaylor said: Does anyone have instructions for sharpening rosette cutters? I have two punches from Weaver that are woefully dull. Thanks, Randy Send them back to weaver & have them sharpened. Quote Share this post Link to post Share on other sites
bruce johnson Report post Posted January 20 I sharpen the inside edges with a round diamond file. Once i have a bit of a bur all the way around I buff the out edges on a sisal wheel with black compound to take that bur off. I go back and do the inside with a hard felt or small leather wheel on a Foredom (Dremel works on lower speed) to take out grit marks near the edge, and buff the outside again to clean up any straggler burring. Quote Share this post Link to post Share on other sites
rktaylor Report post Posted January 21 Thanks Bruce. I appreciate the advice. Randy Quote Share this post Link to post Share on other sites
rktaylor Report post Posted January 23 @bruce johnson, what grit do you have in the file? It looks like it's 1/4" diameter. Thanks, Randy Quote Share this post Link to post Share on other sites
