sinneD Report post Posted 18 hours ago Greetings all- I ordered parts from member vendor, but while I wait for the brown truck, I wanted to try printing a cap to put on a dowel pin to try and use my new to me T111. If someone could post a pic or two of the part with a couple of reference dimensions I would appreciate it. I'll post the files here for others to use too. Manual: I have tried searching online but no luck. I have looked at the Typical GC6-6 and Consew 1206 ones. While close, I think there's are subtle differences. I have read posts here of people sharing them- is there a files section to the forum that I might be overlooking? thanks in advance sinneD Quote Share this post Link to post Share on other sites
Constabulary Report post Posted 9 hours ago (edited) maybe its me but what dowel pin are you talking about and why does it need a cap - sorry but I have no clue of what you mean. Edited 9 hours ago by Constabulary Quote Share this post Link to post Share on other sites
sinneD Report post Posted 2 hours ago (edited) Anyone have a T111-155 manual? A dowel pin is a finished piece of round stock, precise in its diameter and length. Here is what I came up with. Here is the file if anyone wants it. I was not sure to put it here or in the 3D printer area. Print it with the base down. Use it as a cap on a piece of 1/4"x3" long round stock. You should end up around 82mm length. It works well enough for me until I get a proper part. Then i can compare. knee_lifter.stl Edited 2 hours ago by sinneD Quote Share this post Link to post Share on other sites
