TACSEW T111-155 help: knee lifter rod and manual

[sinneD]

Greetings all- 

I ordered parts from member vendor, but while I wait for the brown truck, I wanted to try printing a cap to put on a dowel pin to try and use my new to me T111. 

If someone could post a pic or two of the part with a couple of reference dimensions I would appreciate it. I'll post the files here for others to use too. 

Manual: I have tried searching online but no luck. I have looked at the Typical GC6-6 and Consew 1206 ones. While close, I think there's are subtle differences. 

I have read posts here of people sharing them- is there a files section to the forum that I might be overlooking? 

thanks in advance

sinneD

[Constabulary]

maybe its me but what dowel pin are you talking about and why does it need a cap - sorry but I have no clue of what you mean.

Edited November 24, 2024 by Constabulary

[sinneD]

Anyone have a T111-155 manual? 

A dowel pin is a finished piece of round stock, precise in its diameter and length.  Here is what I came up with. 

Here is the file if anyone wants it. I was not sure to put it here or in the 3D printer area. Print it with the base down. Use it as a cap on a piece of 1/4"x3" long round stock. You should end up around 82mm length.   It works well enough for me until I get a proper part. Then i can compare. 

knee_lifter.stl

Edited November 24, 2024 by sinneD

[crazyguy]

I had the manual at one time but it was identical to the typical manual that you mentioned. No real useful information and terrible pictures. I no longer have the machine