How to add needle positioner on adler 669

[HarrySingh]

Hi, I am looking to add needle positioner on adler 669 eco. I haven't find part required to install on part manual of 669.

Do anybody knows how to please share the hack @shoepatcher, i think you have done it...please share specific part or DIY solution...plzzz

Other thing, Do Ho hising G60 power is enough for 669?

[shoepatcher]

 You need DA  part #0667105100 which is  the stud  for synchronizer.  Remove plastic plug and tap the stud in place.  This is what the synchronizer mounts on.

glenn

[HarrySingh]

Hi Glenn,

Thanks alot for the reply.

Just checked on google the part no mentioned and find on 867 manual and the screen short of the part is this...

Do it's needed to screw , I think their is no hole in Shaft or i may need to recheck.

Do 600 watt [Hohising g60] in enough for 669?

Edited September 2 by HarrySingh

[HarrySingh]

@shoepatcher

Do i needle to drill hole and thread with tap for screw to hold it or just it has tight fit , please advise....

[HarrySingh]

@shoepatcher @kgg Do i needle to drill hole and thread with tap for screw to hold it or just it has tight fit , please advise....