Seems I broke my Juki-LS-341, again... (Bobbin Shuttle)

[Yoshi888]

Finally had some time to properly check and fix everything.
I first readjusted the gear on the horizontal axis, but that did not seem to make too much of a difference.

Next, I checked where the play on the horizontal axis came from. So I removed the Belt cover and opened everything up.
I found that the bushing that keeps the axis in place (as shown in the screenshot) had come loose.
Resetting that part removed all the play in the axis and also stopped my machine from locking up!

So it seems I have found the culprit and fixed it!
The only remaining problem seems to be that while doing all that, I have changed my needle timing after all...
As seen in the video below. It seems in the end I will also have to learn how to adjust the needle timing.

At least once I learned that as well, I am confident I probably will not need a mechanic for my machine anytime in the near future, which is good as the next one is more than 200 km 😂

@AlZilla @friquantThank you so much for the help, I appreciate it a lot.
Do you also have any tips or resources for setting the needle timing :)?

Kind Regards 
Josh

[friquant]

Nice work finding the offending bushing! 💥

Here are a couple of excellent videos by Uwe on the general practice of setting timing:

https://www.youtube.com/watch?v=1wNBPX8i524
- video by Uwe of Consew 225

https://www.youtube.com/watch?v=pL9WiZeKZAY
- video by Uwe of Adler 67

Since these videos are conducted on a different machine, what you actually loosen and adjust will differ but the overall principle is the same.

Your juki user manual will have factory specs for needle bar rise, needle bar height, and hook to needle distance. These will be adequate to get you sewing again. After you become a pro at timing by the book, you might also enjoy How to Stuff a Hook and New Way to Measure Timing. 

[AlZilla]

I'm not familiar with that particular machine but the basic process is to roll the machine over until the needle rises about a quarter inch or 3/8" back up from the bottom. Then find whatever you need to loosen the shuttle hook so you can rotate it. Set the point of the hook right above the eye of the needle, exactly in line with the needle.. The exact measurements will probably vary for your specific machine but should be close enough to stitch.

The hook should all but touch the needle. There a spec and a way to adjust it if needed.  Also, if the point of the hook doesn't align right above the eye of the needle, you may have a needle bar height adjustment to make.

For me, the big thing is to remove things like needle plates and food dogs so I have a good, clear view.

Do it a couple times and you can do it in your sleep.