Weaver embosser: how does it work

[Loren S]

I have been trying to figure out how the weaver Master Tool Creaser and Embosser is able to release pressure and lift up to move belt and then put pressure back to where it was and how the gears fit into all this. I would love to see some pictures of how this is done.

Thanks

[DwightT]

I don't have one of these tools, but I went to the Weaver web site to take a look.  On the page for the tool they have a couple videos showing how to set up and use the tool, including how to leave a blank space by releasing pressure, advancing the leather, and then re-applying pressure.  I think that is what you are looking for?  The page for the tool is at https://www.weaverleathersupply.com/products/master-tool-creaser-and-embosser  The videos are at the end of the list of photos.

Hope this helps.

[Loren S]

Thank you, I did watch that video, but I would like to see the inside, to see how they designed it. I have searched to try to find a picture of the inside but all I can find is how to make adjustments which are all done on the outside of the machine/embossor.

I am looking for pictures of the inside (with cover off) of the Weaver Master Tool Creaser and Embosser where the gears are and the release mechanism is. I would like to see how they designed it.

Thanks

 

[AlZilla]

I flipped this over to Leather Machinery. Let's see if we can get some action over here.