setting rivets

[Spence]

I've been sitting on this question for months because it's got to have a super-simple answer. But it's time to bite the bullet.

When I try to put rivets in my gear, they look like they were done under the influence. Mostly, the problem is the holes I punch. I'm using a handy tandy hole puncher (pliers type). I mark out the where, and it's all downhill from there.

I've tried using a smaller punch to get the correct punch tool set up right and it still looks like crap. If I try to put three rivets in a row across a strap, it's embarrassing.

I need some help here.

Tks

[wildland]

I measure in from the side and mark and then I measure down from the top and put a mark. I use these two marks to line up the edge of the cutting tube. This works better for me than trying to center it on a single mark. The rivet will cover the marks when you put it in, or you can mark on the back.

[DG Leather]

I used the tandy pliers type once,,,,had nothing but trouble......but I use the cheap tandy hand tool punch...i think it cost 4 dollars.....and it is the bestest ever! there is maxi and mini punch sets.....both come with hand tool with detachable ends......works great....

[whinewine]

While holes could be too large, it could also be that you're using rivets that are too long for the thickness of the leather. If they tend to shift (or roll)from side to side, the rivets are too long. Just a suggestion.

russ

[wildland]

  whinewine said:

While holes could be too large, it could also be that you're using rivets that are too long for the thickness of the leather. If they tend to shift (or roll)from side to side, the rivets are too long. Just a suggestion.

russ

Whinewine is absolutely correct if the rivets are to long the straightest holes in the world wont help you. I typically like mine to stick about an 1/16 of an inch out the top of the peices I'm rivieting.

[pete]

cut a piece of plastic about 6" long and 2" wide..

Set your dividers for 1" and use a sharpie to mark a line lengthwise at 1".

Now you have a centerline.

Mark the line at 3/4" or 1" intervals and punch holes in it.

Now you have a "universal" centering device for belts, snaps, rivets etc.

I've had the same problem in the past and strangely enough, I was thinking about this tip THIS MORNING just before I logged on!!!!!

pete

[Spence]

Why didn't I ask this one months ago? It's like asking directions when I'm lost.

Great suggestions and I'll try them all.

The length of the rivets isn't the problem.

The holes appear to be right - I have to push the rivets in.

I do believe I'm using the wrong tool though and will invest in a mini-hand punch set (for starters)

Marking the top and side of the hole and lining the punch up is an outstanding idea.

As soon as I can wrap my brain around how to use the 'universal' plastic guide, I'll make up one of those too.

Thanks all.

[pete]

As soon as I can wrap my brain around how to use the 'universal' plastic guide, I'll make up one of those too.

Thanks all.

rough but here it is. Center it anywhere and you have 3 holes in line. Hope this is what you needed!

pete

[Spence]

  pete said:

As soon as I can wrap my brain around how to use the 'universal' plastic guide, I'll make up one of those too.

Thanks all.

rough but here it is. Center it anywhere and you have 3 holes in line. Hope this is what you needed!

pete

That's great - Thanks Pete