Members CajunMojo Posted May 5, 2010 Members Report Posted May 5, 2010 (edited) Made a head knife from a circular saw blade yesterday. It needs to be sharpened and polished and of course a handle. Any Advice. Edited May 5, 2010 by CajunMojo Quote
Contributing Member TwinOaks Posted May 5, 2010 Contributing Member Report Posted May 5, 2010 Make sure you retemper the edge after any grinding, and take your time so you don't have any soft spots. A lot of circular saw blades are made from L6 steel which while durable, can rust pretty quickly. For your primary taper, try 22 degrees. Quote
leatherman1457 Posted May 6, 2010 Report Posted May 6, 2010 Made a head knife from a circular saw blade yesterday. It needs to be sharpened and polished and of course a handle. Any Advice. Andy , It is looking good. Can't wait to see the finished project.I bet it will look nice. And you tell me you are a begginer. rightttt .Gary Quote
electrathon Posted May 6, 2010 Report Posted May 6, 2010 Circular saw blades are usually very soft. Not sure if it can be properly tempered or not. I always use hand saw blades. Quote
Contributing Member TwinOaks Posted May 6, 2010 Contributing Member Report Posted May 6, 2010 I made a little sheath knife out of a cir. saw blade styled after a Mora knife. Using a torch I took it to the transitional state and quenched in water. (oil might have been better) Tempered it to "straw" w. the torch and parkerized it. No issues with edge holding that I can see. Of course, it doesn't get hard use like a field knife should, but for the little bit of testing I did, it held up. I guess a lot will depend on the blade steel itself, too. Electrathon, are you using new saws or finding old ones and cleaning them up? Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.