Clip-on Utility Knife Sheath

Members

$$hobby

Members
- 423
Gender:Male
Location:Oregon, NW, USA, PNW, Americas, Earth, SOL, 3rd Planet,45°34'05.5"N 122°41'36.8"W 45.568187, -122.693547
Interests:Horses, guns, horses and more guns. did i mention leatherwork? Not doing so much leather work now. Trying to downsize some of my life and keep on working, saving for retirement and travel. More Travel now. Less horses unless i can pickup a ride on my travels.
Leatherwork Specialty:so far, lots of english tack repairs, brow bands, holsters, gun belts and anything i may want to make.
Interested in learning about:horses, saddle making.....

Members

- Report

Posted June 15, 2008 (edited)

Well, i decided to make another holster. But this time for my utility knife. I used one of those clips that i had around for a long time. For the holster itself, i used some heavy scrap. The outside and inside is 12oz and the back that supports/holds the clip in place is approx 6 oz. i did the casing technique on the outside as can be seen and it holds the knife body in place real nice. of course its hand stitched.

it actually came out okay eventho i thougth it was going to be too large compared to what its holding. this was a fun and fairly quick project.

Edited June 15, 2008 by $$hobby

Quote

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.