Clip-on Utility Knife Sheath

[$$hobby]

Well, i decided to make another holster. But this time for my utility knife. I used one of those clips that i had around for a long time. For the holster itself, i used some heavy scrap. The outside and inside is 12oz and the back that supports/holds the clip in place is approx 6 oz. i did the casing technique on the outside as can be seen and it holds the knife body in place real nice. of course its hand stitched.

it actually came out okay eventho i thougth it was going to be too large compared to what its holding. this was a fun and fairly quick project.

Edited June 15, 2008 by $$hobby