Tex Shooter Report post Posted December 22, 2013 I had not seen a pony configuration like this, so I just threw together this pony with scrap to try it out. It is not finished and I will either tear it down and re-do it or tweak it quite a bit. It was meant as a concept prototype. The idea behind it is to clamp it to a table and then slide up to it to stitch. The pony as it sits works, but it could use some tweaking. A bolted on 2 inch by 1/8 aluminum angle Is what holds the clamp to the table clamping board. The tips have Barge glued vegetable tip inserts. It is strong and does not flex around. I will put more gap at the bottom for clearance and about make 2 or 3 inches shorter overall. The angle is mounted upside down to give more throat. I used a hinge at the bottom and found out that was a mistake. This is my first attempt at making a stitching pony and I have learned a lot. -- Tex Quote Share this post Link to post Share on other sites
stanly Report post Posted December 23, 2013 Good u realize ver 1.0, it will need much wider throat to be very useful. Quote Share this post Link to post Share on other sites
PappyUSA Report post Posted December 23, 2013 Very nice! Quote Share this post Link to post Share on other sites
