Joeyd7 Report post Posted July 25, 2014 Hi, Is there any benefit to turning the top 3 hole thread guide horizontal compared to vertically? I see many people turn them horizontal and was curious if there was any difference? Thanks. Quote Share this post Link to post Share on other sites
Constabulary Report post Posted July 25, 2014 Sometimes - it depends on the angle that the thread runs into your thread tension discs. Having a flat angle can prevent the thread from popping out of the discs sometimes. I had this with a friends Singer 211. A flatter angle solved it. Quote Share this post Link to post Share on other sites
