Rohn Report post Posted November 5, 2014 Made this sheath for a customer. All hand stitched. I used Fiebings Mahogany Oil Dye and Tan Kote for the finish. All comments welcome. Quote Share this post Link to post Share on other sites
Chief31794 Report post Posted November 5, 2014 Looks great. Good craftsmanship. Chief Quote Share this post Link to post Share on other sites
Rohn Report post Posted November 5, 2014 Thanks Chief. I really enjoyed putting this one together. Quote Share this post Link to post Share on other sites
stu925 Report post Posted November 5, 2014 (edited) Looks great, I really like those full sheaths as opposed to just a mask to cover the edge. I need to make one for my camp axe like that one of these days just need to get through the rest of my work first. Stu Edited November 5, 2014 by stu925 Quote Share this post Link to post Share on other sites
Rohn Report post Posted November 5, 2014 Thanks Stu. It was a fun project. Quote Share this post Link to post Share on other sites
InfiniteChain Report post Posted November 5, 2014 Are my eyes deceiving me? Are there 4 layers at the haft? Quote Share this post Link to post Share on other sites
Rohn Report post Posted November 5, 2014 Yes, four layers at the haft, then feathered down to three layers across the cutting edge. Quote Share this post Link to post Share on other sites
InfiniteChain Report post Posted November 5, 2014 I'm glad I'm not going blind! Nice job! I'm pretty new to the craft. It would be cool to see a tutorial on that. How deep does the middle layer around the blade edge go? Quote Share this post Link to post Share on other sites
Rohn Report post Posted November 5, 2014 It goes in from the edge about 1/2". 1/4" past the stitches. It is also glued with Barge cement. Quote Share this post Link to post Share on other sites
InfiniteChain Report post Posted November 5, 2014 Thanks for the continued info. Did you stitch all three layers at the same time? If so, how much more difficult is that than just stitching two layers together? Quote Share this post Link to post Share on other sites
Rohn Report post Posted November 5, 2014 I stitched all of it at the same time. More layers makes it a bit more difficult but not too bad. I punched the holes for the stitching by putting an awl needle in my drill press, that way I was able to punch the holes straight through and the stitching is straight on both sides of the project. Might not be the traditional way of punching the stitching holes but it works great for me. I use lacing pliers to persuade the needles and thread to go through the holes. Quote Share this post Link to post Share on other sites
InfiniteChain Report post Posted November 5, 2014 Work smarter, not harder. That's a great idea using the drill press! Quote Share this post Link to post Share on other sites
Wild Bill46 Report post Posted November 8, 2014 Hey many Thanx Rohn ! I'm designing an axe sheath at present, and was stumped as to some sort of an original idea. This looks good enough to steal from you ? If you woulden't mind ? Great works, Congratulations ! Wild Bill46 Quote Share this post Link to post Share on other sites
Rohn Report post Posted November 8, 2014 Hey Wild Bill, Help yourself to any ideas you get from any of my posts. That is part of the reason for posting them. Quote Share this post Link to post Share on other sites
Wild Bill46 Report post Posted November 8, 2014 Thanx again Rohn ----------------------------- and thanx for your many posts, I always enjoy seeing your projects ~ Wild Bill46 Quote Share this post Link to post Share on other sites
