builderofstuff Report post Posted December 3, 2014 This is a stamp that I milled out tonight using acrylic as a material. I was surprised that it worked as well as it did and seemed to be more than strong enough. My cutter that I was using for the cleanup pass broke and so I ended up doing the cleanup work by hand with the dremel tool. Chris Quote Share this post Link to post Share on other sites
builderofstuff Report post Posted December 3, 2014 Stamped a bit deeper and then I touched up a couple of spots with the back of an x-acto knife to add in some finer details. Chris Quote Share this post Link to post Share on other sites
MonicaJacobson Report post Posted December 3, 2014 Very cool, Chris! Quote Share this post Link to post Share on other sites
builderofstuff Report post Posted December 3, 2014 Thanks. It all started because I wanted to make a makers stamp, I'm sure eventually I'll actually get around to it. LOL This particular stamp was made from a graphic that I used to make an airbrush stencil. Chris Quote Share this post Link to post Share on other sites
TwinOaks Report post Posted December 3, 2014 very cool, and I'm surprised that the acrylic is holding up as well as it is. Quote Share this post Link to post Share on other sites
builderofstuff Report post Posted December 3, 2014 Me to. I didn't really expect it to. It's milled from a 1/2" thick piece. Chris Quote Share this post Link to post Share on other sites
builderofstuff Report post Posted December 3, 2014 I think I might take some 1/4" aluminum and epoxy it to the back of the stamp to make it even stronger, but so far it seems like it works fine without it. Chris Quote Share this post Link to post Share on other sites
