steelhawk Report post Posted May 7, 2015 I had a problem with thread on my machine and somehow poked a small hole where one shouldn't be. It is only through the top layer of a brown holster. What is the best way to fix it, it there is one? Quote Share this post Link to post Share on other sites
camano ridge Report post Posted May 7, 2015 (edited) I have occasional poked a hole where it should not be. I use a diamond awl and find after a while a considerable amount of the hole heals up. I take the tip of my awl handle (which is round) and kind of push and rub the hole ares this also helps close the hole. dye it the rub a little bees was into the hole If any hole is still apparent. Doing all of this it should pretty much disappear. Edited May 7, 2015 by camano ridge Quote Share this post Link to post Share on other sites
steelhawk Report post Posted May 7, 2015 What about a little bit of Tandy Leathercraft Cement dyed brown, then rubbed into the hole? Quote Share this post Link to post Share on other sites
