Members larry1096 Posted June 20, 2015 Members Report Posted June 20, 2015 Is there a specific technique I can use to avoid getting the (seemingly) unavoidable strings and drips of Barge cement all over my work piece? I always manage to get at least one sticky, stringy blob dropped right where it will show. Is there a trick, or a better product? Thanks, Larry Quote
Chief31794 Posted June 20, 2015 Report Posted June 20, 2015 You might try thinning it a little, use a paint brush (not the brush in the can I normally cut it off), I buy brushes for ~ $.50 each, use once, charge it to the project incidentals, they are 1" wide and fit right in the can. Then I also make sure I invert the brush after letting the excess fall away and keep it inverted until I get it over the intended area. It takes some patience. Hope this helps. Chief Quote "Life's too short to carry ugly leather"
Contributing Member JLSleather Posted June 20, 2015 Contributing Member Report Posted June 20, 2015 (edited) Put a piece of paper over the spot where you dont want glue. If you're just trying to glue somewhere in the middle, and don't need to see the UNglued part, then a sheet stolen outta yer printer will do. If you would like to be able to see the unglued section, then wax paper is the ticket. Yeah, like the stuff Mom had for putting cookies out the oven (don't tell Mom I got it). Oh, and if yer talking about the quart thing with the brush in the lid, then yeah, what Chief said! Hobby Lobby girl sends me little "utility" brushes, good n long, only about 3/4 or 1" wide, and like 6 fera dollah... Edited June 20, 2015 by JLSleather Quote "Observation is 9/10 of the law." IF what you do is something that ANYBODY can do, then don't be surprised when ANYBODY does.
Members cgleathercraft Posted June 21, 2015 Members Report Posted June 21, 2015 Don't load the brush with so much glue (if possible i know some pots it's hard to control). Going back to the pot 3 or 4 times is less of a headache then glue where it shouldn't be. Quote http://www.cgleathercraft.com Member of the Iron Brigade.
Members larry1096 Posted June 21, 2015 Author Members Report Posted June 21, 2015 Thanks for all the good suggestions! I'm planning to use all of them- I will add an idea my mad googling turned up, although I'm afraid I can't find the link and give proper credit to the author- Hold the workpiece upside down, and glue from the bottom-any strings or drips will fall AWAY from the leather, and the strings can usually be pulled away without getting any cement on the work. Between all these ideas, I will just have to blame myself for sloppiness if this happens again, I think! Larry Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.