Uwe Report post Posted June 22, 2015 Having seen the nice LED sewing lights that are available for many newer machines, I decided to try and retrofit my Adler 205 with a homemade LED sewing light. I used two LED light bars and a small battery case that holds three AA batteries. The installation is mainly via tiny magnets that I glued to the plastic drip tray. It makes for a nice, shadow-free light that is super bright. It only adds about 1/4" under the drip tray, so it doesn't get in the way. The pictures are of the working prototype. I'll work with it for while to check if there any usability issues that require modifications. As usual, I hope the pictures tell much of the story. Quote Share this post Link to post Share on other sites
Gregg From Keystone Sewing Report post Posted June 22, 2015 Very nice, clean looking install. When you put these types of lamps onto machines, you don't notice how much light the produce until you turn it off! Quote Share this post Link to post Share on other sites
Cobra Steve Report post Posted June 23, 2015 Great job! Quote Share this post Link to post Share on other sites
