Uwe Report post Posted July 24, 2015 (edited) Due to the lack of nice table attachments for 335 class machines I've been working on my own design over the past few weeks. Rather than doing a one-off, I've decided to put a little more manufacturing thought into it so I can make more if I want. It's far enough along to share a few sneak peek pictures. This version attaches directly to the arm via three knobs. The board is made from bamboo, the white insert is powder coated aluminum, and the bobbin access plate is polished steel (held in place by three magnets). The knob on top of the arm uses a little cup to isolate the pivoting feed dog arm from the table to avoid binding.The whole affair installs in under a minute without tools and is surprisingly solid. I'm still fine tuning a few details and will probably make a few extras to sell after get back from vacation (watch out Trox, I'm heading to Oslo!) Here are a few pictures of the current state of development: Edited July 24, 2015 by Uwe Quote Share this post Link to post Share on other sites
Constabulary Report post Posted July 25, 2015 (edited) that really looks nice - so when will you start mass production? Edited July 25, 2015 by Constabulary Quote Share this post Link to post Share on other sites
Andrew Chee Report post Posted July 26, 2015 Very nice. I had a local machinist make me something similar because I couldn't find anything that worked. I totally would have bought this had you been selling these when i was looking. You should sell them. Andrew Quote Share this post Link to post Share on other sites
Uwe Report post Posted July 26, 2015 Thanks guys! I am busy making enough parts to put about a dozen or so of these table attachments together. They'll be for sale starting in late August when I get back from Europe Quote Share this post Link to post Share on other sites
