56FordGuy Report post Posted July 26, 2015 I'm working on a smart phone case, but have hit a roadblock. My idea is basically a t shape, folded over and the two 'arms' sewn to the lower leg. I'm stuck there though, because when it's folded there's not room to get a needle through the inside. Adhesive would hold it, but I would feel better with a mechanical connection as well. Rivets might be a possibility, but then I might need to line it to prevent them from wearing against the phone and I don't know how I could do that with it all closed up. I'm sure I'm not the first person to have this idea. Any advice for a beginner would be appreciated. Quote Share this post Link to post Share on other sites
dirtclod Report post Posted July 26, 2015 Velcro ? Quote Share this post Link to post Share on other sites
Troy Burch Report post Posted July 26, 2015 get a couple of curved needles. they'll reach right in there. Quote Share this post Link to post Share on other sites
56FordGuy Report post Posted July 26, 2015 (edited) Velcro ? Velcro wouldn't work, it's the back of the case where the slots for the belt will be. get a couple of curved needles. they'll reach right in there. I'll have to look into that, didn't know they made those. The end of the stitches would be almost 4" down though, so it's quite a reach. Edited July 26, 2015 by 56FordGuy Quote Share this post Link to post Share on other sites
Troy Burch Report post Posted July 26, 2015 (edited) Maybe a pair of needle nose pliers to reach down in there. Edited July 26, 2015 by Troy Burch Quote Share this post Link to post Share on other sites
