indidana Report post Posted September 1, 2015 I hope I got your attention with the title! I really need some help here. I'm looking for a pattern/template for a holster for a .357 s&w ladysmith. It's going on a shoulder rig so I need it to have a bet loop on the back rather than a clip, but I can easily change that part of the design. I'm also looking for a shoulder rig that is better suited for women. Seems like everything I've seen is more for men. I've got a one size fits all deal, but would like a pattern/template for women if there's one out there. Lastly, I need to make a couple, or one large pouch for two speed loaders. All of this is pretty new to me. I haven't been doing leather for very long and would really appreciate any and all help. Thanks y'all! Quote Share this post Link to post Share on other sites
JLSleather Report post Posted September 1, 2015 (edited) Like I'm not gonna read THAT one! I did reply to your question over there ← on that other site. Putting that here in case someone else can help with it further... I have the small revolver pattern for the Smith J-frames, but I'm unsure of the fit on the ladysmith (which if i remember is an I-frame). It does fit the Taurus M85 well, so you might find it just fine.I have a desk covered with "dummy" guns to get through, so I don't even know when I could design one. Is there a dummy for that one? Maybe could pick one up and shove it in teh j-frame holster to test ... EDITED FOR CORRECTION: The Ladysmith was originally an "M" frame revolver. Now, you may well find J-frames being referred to as "ladysmith" models. Edited September 1, 2015 by JLSleather Quote Share this post Link to post Share on other sites
