chapman Report post Posted January 14, 2016 First of all I want to thank JLS for his generous pattern and instruction downloads. It's really helpful to us beginners on here to have a few guys like him that don't mind sharing thier knowledge and experience with everyone so thanks from an old guy and as promised here is my first one. Hope you like it .. more to come.. Quote Share this post Link to post Share on other sites
JLSleather Report post Posted January 14, 2016 (edited) Lines lookin' straight, and the stitchin' looks good. I even like the inlay, though ostrich aint m' favrite Not sure why, but your stitch line looks quite a ways from the trigger guard. Did you have some stretch in there? Your leather should form a bit of a corner under the turns, a bit like this.. If it doesn't, it's likely due to leather stretch, or stitching too far outside one or more lines, or using leather notably thinner than suggested. Edited January 14, 2016 by JLSleather Quote Share this post Link to post Share on other sites
BruceGibson Report post Posted January 14, 2016 Nice work! The Glock 19, 23 and 32 are some of my favorites to build for. Quote Share this post Link to post Share on other sites
chapman Report post Posted January 14, 2016 I moved the stich lines over a bit because i never could get the 6" printout on my printer so being on the safe side for fit i moved them over. This was my first holster like this so it was more of a test for several things. And yes the leather was a little lighter than you suggest but was all I had . But I'm learning.... Quote Share this post Link to post Share on other sites
JLSleather Report post Posted January 14, 2016 Learning is what those files are about, so that's good! To get the correct scale, you may have settings at your printer AND in the program you use to open the file (usually Acrobat). Quote Share this post Link to post Share on other sites
JLSleather Report post Posted January 15, 2016 Did you try to make the mag carrier too? Still good practice, don't use up much leather, and more important you can see if it prints correctly (might show you the setting that's causing you trouble). Quote Share this post Link to post Share on other sites
chapman Report post Posted January 23, 2016 no I haven't tried the mag pouch yet but I think I have my 6" sizing fixed but I already started a 1911 with the small pattern it came out ok but a little tight because I lined it I will post so you can see.. the next ones will be a true 6" layout thanks again.. Roger.. Quote Share this post Link to post Share on other sites
