Contributing Member JLSleather Posted February 16, 2016 Contributing Member Report Posted February 16, 2016 (edited) New (used twice) from TX custom dies. Makes right handed holster for the Sig P938 (and some say also the 238). Selling it at cost, and will include the stitch pattern. $75 incl shipping in US. Photo later today. Edited February 16, 2016 by JLSleather "Observation is 9/10 of the law." IF what you do is something that ANYBODY can do, then don't be surprised when ANYBODY does.
Contributing Member JLSleather Posted February 16, 2016 Author Contributing Member Report Posted February 16, 2016 Oh, and somebody remind me I have a brand new slot punch from them too... A bit longer than I wanted. Could be I didn't describe what I wanted quite rightly... figures- the one time I don't send a drawing Slot punch with 'flipper' intended for use in a press (no handle). I did try it out, cuts real nice - just wrong length. Pictures of that one shortly also. "Observation is 9/10 of the law." IF what you do is something that ANYBODY can do, then don't be surprised when ANYBODY does.
Contributing Member JLSleather Posted February 17, 2016 Author Contributing Member Report Posted February 17, 2016 (edited) Okay, then... here's teh holster clicker die. That's a 6" scale in the picture. This is made with a belt loop -- while there's no die for the loop, I'll include the pattern with the die. Oh, maybe should mention that this will likely work for the Colt Mustang also. Edited February 17, 2016 by JLSleather "Observation is 9/10 of the law." IF what you do is something that ANYBODY can do, then don't be surprised when ANYBODY does.
Contributing Member JLSleather Posted February 17, 2016 Author Contributing Member Report Posted February 17, 2016 (edited) And, here's teh slot punch. Some already familiar with the way this is done, but it stands on it's own in the press - no handle needed. Punches a slot just OVER 1 5/8" long (down the middle) by about 1/4" wide. Very sharp (I think this is the second slot it punched), punches cleanly. That's a piece of 7/8 H.O. in the pic. Oh... forgot a price. I'll have to dig in receipts.. think this one is about the same price? The way it stands alone is shown in the back of this picture... a metal tab attached to some type of compressible foam to make it stand without punching outside teh slot.... Edited February 17, 2016 by JLSleather "Observation is 9/10 of the law." IF what you do is something that ANYBODY can do, then don't be surprised when ANYBODY does.
Contributing Member JLSleather Posted February 18, 2016 Author Contributing Member Report Posted February 18, 2016 Holster die is sold. Still got a slot punch - and there's more when I get around to going through "Observation is 9/10 of the law." IF what you do is something that ANYBODY can do, then don't be surprised when ANYBODY does.
Recommended Posts