New and improved USB leather cover

[Rublackett]

Thanks to your feedback on my other post:  

I have improved my work and I'd like some more feedback! Thank you. Please remember that I am only 15 years old and I haven't been doing leathercraft for long 

https://imgur.com/gallery/TgkcT

[Brown64]

Looks fine to me. Your stitching will improve with practice. It be such a small project it would be more difficult to stitch anyway.

[Halitech]

stitches should be closer to the USB drive or it will loosen and fall out

should cut off a lot more of the excess on the edges or they will pull apart

I'd put a grommet or eyelet in the hole where you have the key ring

I'd figure out some way of putting a flap over the tip to protect it as well, especially since it's being carried upside down

[David8386]

I looked at it and agree with Halitech on the eyelet and carrying it on a key chain like that it will fall out or either bend the end up or worse get something in it. If it's not an important flash drive you could put a little rubber cement on it when you  put it together and that should help keep the drive in the holster but then you would have to leave it in there all the time. That means you have to either take it off the keychain or have your keys plugged into the computer.  At least you would always know where your keys are. Another idea would be to make it set deeper in the pocket and have it hang from the other end so it doesn't try to fall out. Just some ideas. I do congratulate you on designing something yourself that is really great so keep it up.

 

David