Jump to content

Recommended Posts

  • Members
Posted
9 hours ago, VanRhodes said:

CowboyBob: I did loosen the screw in an attempt to slide the shuttle race closer to the needle (just like I did on my adler 20), but this one is properly stuck for some reason. Its not even budging.  

Sounds like you have to fix it with a hammer to move it.  Preferably a leather mallet would do it.  Don't over tighten the screw, it can break the casting and create a true mess.

SLH Owner Page.JPG

Industrial sewing and cutting, parts sales and service, family owned since 1977, Philadelphia, Pennsylvania USA, 215/922.6900 info@keysew.com www.keysew.com

  • Replies 32
  • Created
  • Last Reply

Top Posters In This Topic

  • Members
Posted

It looks the same as my Adler 20 and 21. Should it move after loosening screw 3? I never managed to move them. They where realy realy stuck stuck stuck. Maybe I wasn't mad enough? Should give it a try next time.

Sandy.

  • Members
Posted

On my Adler 20 I can move it buy gently tapping it with a mallet, on the 7-33 however, it's a completely different story. I did try tapping it with a mallet but perhaps I wasnt using enough force. 

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...