Members lablevens Posted March 16, 2017 Members Report Posted March 16, 2017 II have a 2 inch English End Punch that the edge has roll.Need someone to grind the edge down and put a new sharp edge on.Or would it be cheaper to just buy a new one? Thanks!!! Quote
Members Mattsbagger Posted March 16, 2017 Members Report Posted March 16, 2017 Check out the sharpening tutorials on this site and some on YouTube also. Be a good start. Quote
Members Hillbilly tim Posted March 16, 2017 Members Report Posted March 16, 2017 unless the punch was made from some junky metal, you should be able to save it easily enough. File or stone to straighten it up then, put ome time in learning to sharpen correctly, then practice it. Quote
Members lablevens Posted March 16, 2017 Author Members Report Posted March 16, 2017 (edited) Maybe roll was the wrong word to use.It would need to be ground down about 1/8 inch all the way around and then a new edge done.My grandson hit it just a little to hard.Update:I just spoke to the folk down in Texas and I'm going to have a clicker die made.Thanks for the reply Edited March 16, 2017 by lablevens Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.