Mockingbird Report post Posted April 23, 2017 I have a servo motor with P S + - keys on it and want to reverse the direction of the motor. I read that holding - (down) button will take me to menu... That's not working. Any ideas? I feel like a safe cracker trying all combinations of these four buttons Quote Share this post Link to post Share on other sites
Uwe Report post Posted April 23, 2017 (edited) You'll need to give us more than "P S + -". Brand and model and a photo of the motor would be useful. It's nearly impossible to guess which settings the various manufacturers programmed into these control units. There are no standards, really. You may need to track down a manual. Edited April 23, 2017 by Uwe Quote Share this post Link to post Share on other sites
Mockingbird Report post Posted April 23, 2017 This under a different brand. Cheers! Quote Share this post Link to post Share on other sites
Uwe Report post Posted April 23, 2017 My Sewpro has the same interface. Try these: Quote Share this post Link to post Share on other sites
Mockingbird Report post Posted April 23, 2017 Thanks Uwe. Ok I tried P and S at the same time but it's still the flashing 0 (standby sign?). Any ideas? Quote Share this post Link to post Share on other sites
Mockingbird Report post Posted April 23, 2017 Solved. For this version you need to hold P and +, and it's a completely different Parameter table to above e.g. P-07 exists in this one. Cheers Uwe anyway. I'm sure countless people on here owe you a few beers Quote Share this post Link to post Share on other sites
