Jump to content

Recommended Posts

  • Members
Posted
  • Members
Posted

Installed. yes clutch motor..1720. may have to get smaller pulley. So far so good.

Would an adjustable belt work so I wont have to cut my table up to much?

Friend said "tell them it wouldn't even turn when purchased". Screams now.

 

20170427_181904.jpg

  • Members
Posted

I will also need to relocate bobbin winder further back.

So that raises the question if the adjustable belts work on their backside?

Leather belt seems inadequate.

Thanks for input.

  • Members
Posted

I was able to check with 2 matching presser feet. Seems as though the front foot mechnism is bent towards the right. they still would bind and needle is off center within foot.

I plan to take apart and inspect what I believe to be: part #91-108-002-91 page 37 (10)  along with corresponding parts. My Pfaff145 is the H4 the other part similar seems to be for the H3 (108-001-91).

So another question along with the belt question is this part available if its bad? (And I think like I'm on the right track.)

I had no hits from a search. thanks for reading. Paul

  • Members
Posted

Regarding the belt, I would just cut through between the holes to make a slot, then you can use standard belts. It will be much easier in the long run.

Machines wot I have - Singer 51W59; Singer 331K4; Seiko STH-8BLD; Pfaff 335; CB4500.

Chinese shoe patcher; Singer 201K (old hand crank)

  • Members
Posted

I took out the presser bar? in question and it was fairly straight. Needle/bar is straight. Feet do not match up. Front foot does not sit square if centered to needle. ($95 + parts machine and I dont need parts). Seems more like a shim missing or their is a twist in the vertical cast arm that walks it?

Anyone ever troubleshoot/replace these parts before? Based on being damaged or worn? Think their is a commercial sewing machine center near Portland when I give up.

20170429_155213-1.jpg

I took out the presser bar? in question and it was fairly straight. Needle/bar is straight. Feet do not match up. Front foot does not sit square if centered to needle. ($95 + parts machine and I dont need parts). Seems more like a shim missing or their is a twist in the vertical cast arm that walks it?

Anyone ever troubleshoot/replace these parts before? Based on being damaged or worn? Think their is a commercial sewing machine center near Portland when I give up.

20170429_172015-1.jpg

  • Members
Posted

Considering the only info I can find are parts I'm guessing and removing and reinstalling. this photo shows a grey area that I wonder if there is supposed to be a shim. Its like if the walking mechanism was shimmed a little it may correct issues.

Cant post photo.

 

  • Members
Posted

oops photo too big.

 

 

20170429_172238-1-1.jpg

  • Members
Posted
  • Members
Posted

Narrowed it down to the narrow part of shaft being bent.

Supplier on ebay of this part for H3 says mine is not available. Will attempt to straighten.  Guy I sold some wheels to this weekend is a commercial upholsterer and said he uses standard v belts with hog rings.

Thanks for previous input. 

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...