Looking for a 1 inch (25mm) wide Veiner

[blazeafar]

Hi folks, I am considering making a copy of an old rifle case I have. I want to copy the carving but lack one tool and can not seem to find anyone selling such.

It is a Veiner similar to the Craftool V707 only twice the size, 1 inch x 3/4 inch.

Anyone know what to find one?

Here is a not so good of picture. It is used as a border overshadowing 2 stamps from a V407 Veiner.

[alpha2]

Pic didn't show up.

[blazeafar]

Lets see if this shows up?

I was looking at the way the border was done incorrectly. It is one tool and not two, so I think I found what I need. The Veiner is about 1" (25mm) and is stamped at 1/2" (12mm) intervals.

http://

Edited May 13, 2017 by blazeafar
Change

[alpha2]

Ah, yes. It would be a challenge to get the angle and pressure just right for each bit, but that's what we all have to deal with, isn't it?

I like it, though, it's unique, and gets you a lot more possibilities with fewer tools.

[blazeafar]

There are a few interesting patterns on the piece, it's a shame it is a vinyl gun case of a leather craving!