Studio-N Report post Posted August 8, 2017 new embossing plate to add to my line of FD related ones. cut in brass. I am happy with how this turned out. this is roughly 3" tall for a wallet back Quote Share this post Link to post Share on other sites
machinehead Report post Posted August 8, 2017 Great job as usual. Quote Share this post Link to post Share on other sites
builderofstuff Report post Posted August 9, 2017 Looks great. What kind of machine are you using to route those out? Chris Quote Share this post Link to post Share on other sites
Studio-N Report post Posted August 10, 2017 hello. this was done on a HAAS vertical mill. 15 HP of power! Quote Share this post Link to post Share on other sites
retiredff Report post Posted August 13, 2017 How would you go about coloring something that complex? Very small brush? Quote Share this post Link to post Share on other sites
Studio-N Report post Posted August 13, 2017 I think using an antique gel letting the black pigment fall into the recesses would highlight it pretty well. Quote Share this post Link to post Share on other sites
