thunter9 Report post Posted August 15, 2017 (edited) i had a new timing belt replaced ,old one had a chunk missing. and since it sat for a time had it gone through and oiled and adjusted. it will come with a clutch motor an table w/ bobbin winder and a light and also a after market thread tree. i've set this up to sew 138 thread and it does a great job. should sew chaps and wallets till the cows com home.only reason i'm selling is i've had to move a don't have the room. so if you have the money or you think you have something you think i need let me know. asking $500.00 and i could use a few french end driver punches or a portable machine that will sew canvas weight. i'm located in central iowa and might meet you half way. this is all contingent on where your at. the machine head is in side and the table is in storage like i need to say what it is singer 111w155 compound feed no reverse Edited August 15, 2017 by thunter9 pictture Share this post Link to post Share on other sites
thunter9 Report post Posted August 21, 2017 (edited) On 8/15/2017 at 1:17 PM, thunter9 said: i had a new timing belt replaced ,old one had a chunk missing. and since it sat for a time had it gone through and oiled and adjusted. it will come with a clutch motor an table w/ bobbin winder and a light and also a after market thread tree. i've set this up to sew 138 thread and it does a great job. should sew chaps and wallets till the cows com home.only reason i'm selling is i've had to move a don't have the room. so if you have the money or you think you have something you think i need let me know. asking $500.00 and i could use a few french end driver punches or a portable machine that will sew canvas weight. i'm located in central iowa and might meet you half way. this is all contingent on where your at. the machine head is in side and the table is in storage like i need to say what it is singer 111w155 compound feed no reverse i hope your not troubled that i haven't posted a picture of the table.. its a large K style table. when i gets some help i'll take a picture. as shown the machine head is inside Edited August 21, 2017 by thunter9 Share this post Link to post Share on other sites
