malin823 Report post Posted November 2, 2017 Can someone help me with my knee lift, please? Whom ever installed the knee lift apparently put the horizontal bar in crooked, so as I was using it it came out of the end bracket and the spring fell out and I can't get the spring back on so that it springs back after lifting.... Quote Share this post Link to post Share on other sites
Constabulary Report post Posted November 3, 2017 some pictures would be nice... Quote Share this post Link to post Share on other sites
malin823 Report post Posted November 3, 2017 This is where I "thought" it might go but I don't know where the hook part of the spring goes. Any ideas? Quote Share this post Link to post Share on other sites
Uwe Report post Posted November 4, 2017 (edited) This looks fine to me. Does it not work that way? The spring needs just enough tension to keep the knee pad pushed to the left. Position the movable blocks on the main shaft so that the main shaft has just little play front to back inside the "A"-brackets. The main shaft should have enough play to rotate freely, but not enough play to pop out of the "A"-shaped brackets when you push it towards the back or front. If the "A"-brackets are too far apart, you may have to move one of them. Installing these knee-lift brackets is kind of a pain in the neck (literally). Edited November 4, 2017 by Uwe Quote Share this post Link to post Share on other sites
malin823 Report post Posted November 6, 2017 Thank you...I'm still struggling with it. It seems as if the horizontal bar in the middle is too short. It's a very tight squeeze on either side of the drip pan. You're right it is a pain in the neck.... Quote Share this post Link to post Share on other sites
