superpacker Report post Posted February 4, 2018 I have a Tandy edge creaser and thanks to help from forum members - I’ve got it making nice clean creases - on straight edges. My difficulty is when it comes to going around corners, can’t seem to get a nice clean tight crease. While I’m still new (somit very well could be the user) I am wondering if this tool wasn’t intended to go around outside corners. Any tips? Or is a different tool needed? A wing divider maybe? Quote Share this post Link to post Share on other sites
Chief31794 Report post Posted February 4, 2018 I use an edge creaser up to the corner from both sides, then finish the corner by hand with the ball end of a small modeling tool, lightly mark the corner with it and then "burnish" it with the tool. A little practice and they will look like a continuous groove. Hope that helps, Chief Quote Share this post Link to post Share on other sites
fivewayswelshcobs Report post Posted February 4, 2018 To go round corners the easiest way is to re-angle the crease and continue round the corner using the front tip of the creaser, not tried it with a Tandy one but works well with a Dixons screw crease. With practice can be done in one movement not lifting off the leather, this saves time and keeps the crease neat. Quote Share this post Link to post Share on other sites
