Members sarahvan Posted April 28, 2018 Members Report Posted April 28, 2018 looking for help with the reverse lever on my cobra class 4, it has been slipping down out of reverse while sewing in reverse. I had a look at the manual and it says to 'tighten the nut to make it sew in reverse at the same stitch length as forwards' but the only nut there it the stitch length changing dial nut which is not able to be tightened as such. when pushing the handle into the up position it feels loose already before sewing and then just slips down while sewing. any ideas would be much appreciated!! Quote
CowboyBob Posted April 28, 2018 Report Posted April 28, 2018 Here's the screw you need to tighten just a little at a time until it holds. Quote
Members sarahvan Posted May 23, 2018 Author Members Report Posted May 23, 2018 @CowboyBob thank you so much! Is it possible to send another picture a little more zoomed out? I'm quite sure where are on the machine in that one thanks for the help!! Quote
CowboyBob Posted May 24, 2018 Report Posted May 24, 2018 If you go behind the machine,,open the plate just to the left of where the foot lift chain fastens on. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.