sarahvan Report post Posted April 28, 2018 looking for help with the reverse lever on my cobra class 4, it has been slipping down out of reverse while sewing in reverse. I had a look at the manual and it says to 'tighten the nut to make it sew in reverse at the same stitch length as forwards' but the only nut there it the stitch length changing dial nut which is not able to be tightened as such. when pushing the handle into the up position it feels loose already before sewing and then just slips down while sewing. any ideas would be much appreciated!! Quote Share this post Link to post Share on other sites
CowboyBob Report post Posted April 28, 2018 Here's the screw you need to tighten just a little at a time until it holds. Quote Share this post Link to post Share on other sites
sarahvan Report post Posted May 23, 2018 @CowboyBob thank you so much! Is it possible to send another picture a little more zoomed out? I'm quite sure where are on the machine in that one thanks for the help!! Quote Share this post Link to post Share on other sites
CowboyBob Report post Posted May 24, 2018 If you go behind the machine,,open the plate just to the left of where the foot lift chain fastens on. Quote Share this post Link to post Share on other sites
