Kenl Report post Posted November 16, 2018 Can someone tell me where I can find a rotary hook for my Adler 69 machine. Thanks Quote Share this post Link to post Share on other sites
Constabulary Report post Posted November 17, 2018 Old casting Pfaff 335 (not 335 G) is using the same hook if that helps Not sure where to buy in the US but I usually find everything I need at College sewing in the UK https://www.college-sewing.co.uk/store/Durkopp-Adler-69-Sewing-Machine-Parts Quote Share this post Link to post Share on other sites
shoepatcher Report post Posted November 17, 2018 Contact Bob at Toledo Sewing or Luke at MJ Foley in Detroit. You can get a generic hook by Hirose of Japan or Cerliani of Italy. Both make very good generic hooks and will be cheaper than an original Adler. I have used both manufacturers for years. glenn Quote Share this post Link to post Share on other sites
Kenl Report post Posted November 18, 2018 Thanks guys I appreciate the information.Never have ordered from overseas not sure what to expect or how long it takes. Quote Share this post Link to post Share on other sites
Constabulary Report post Posted November 18, 2018 You for sure have suppliers in the US - this is quite common machine. Quote Share this post Link to post Share on other sites
Wishful Report post Posted November 25, 2018 You may be able to get parts directly from Adler at https://www.duerkopp-adler.com/en/main/Support/parts/ Quote Share this post Link to post Share on other sites
shoepatcher Report post Posted November 26, 2018 You can get parts from Adler but be prepared to pay handsomely. glenn Quote Share this post Link to post Share on other sites
arz Report post Posted November 26, 2018 I bought parts from college sewing also. However, original Adler parts were much cheaper for me to buy direct through my local Adler dealer. You can also get an account at: khsew for feet etc. Good prices. I am looking for a new needle bar...$$$. I wish I could find a generic one Quote Share this post Link to post Share on other sites
Kenl Report post Posted December 23, 2018 Bob from toledo as usual came through for me on the parts. Thanks Bob. NOw if i can get it timed right. been a chore!! Quote Share this post Link to post Share on other sites
shoepatcher Report post Posted December 23, 2018 Timing should not be that hard. Hook and needle working from needle bottom dead center. glenn Quote Share this post Link to post Share on other sites
