tecbuddy1 Report post Posted July 5, 2019 I have been spending quite some time checking out this site and trying to go through my 111w and get it up stitching correctly. After going through all the manuals available - the Army manual, the Navy manual, aircrew manual and the original Singer I have flooded my brain with too much information and can't see the forest for the trees!! I have got my pressure feet at different heights, and my tension controller is now not letting the release shaft open the tension disc. I have pretty much gone back to the original Singer manual and doing each task as it is in the manual. Question...how do you set the feed eccentric to 0? I have my SPI wheel set to the number of SPI but don't see a 0. Thank you ahead of time for your knowledge and assistance! Bill Quote Share this post Link to post Share on other sites
toxo Report post Posted July 5, 2019 Don't know the technical way to do it. I just fix it so the feed dog doesn't move. Quote Share this post Link to post Share on other sites
